mirror of
git://git.openwrt.org/openwrt/openwrt.git
synced 2025-12-13 08:02:09 -05:00
4871fd2616
Device specifications:
* QCA IPQ4019
* 256 MB of RAM
* 32 MB of SPI NOR flash (w25q256)
- 2x 15 MB available; but one of the 15 MB regions is the recovery image
* 2T2R 2.4 GHz
- QCA4019 hw1.0 (SoC)
- requires special BDF in QCA4019/hw1.0/board-2.bin with
bus=ahb,bmi-chip-id=0,bmi-board-id=20,variant=PlasmaCloud-PA2200
* 2T2R 5 GHz (channel 36-64)
- QCA9888 hw2.0 (PCI)
- requires special BDF in QCA9888/hw2.0/board-2.bin
bus=pci,bmi-chip-id=0,bmi-board-id=16,variant=PlasmaCloud-PA2200
* 2T2R 5 GHz (channel 100-165)
- QCA4019 hw1.0 (SoC)
- requires special BDF in QCA4019/hw1.0/board-2.bin with
bus=ahb,bmi-chip-id=0,bmi-board-id=21,variant=PlasmaCloud-PA2200
* GPIO-LEDs for 2.4GHz, 5GHz-SoC and 5GHz-PCIE
* GPIO-LEDs for power (orange) and status (blue)
* 1x GPIO-button (reset)
* TTL pins are on board (arrow points to VCC, then follows: GND, TX, RX)
* 2x gigabit ethernet
- phy@mdio3:
+ Label: Ethernet 1
+ gmac0 (ethaddr) in original firmware
+ used as LAN interface
- phy@mdio4:
+ Label: Ethernet 2
+ gmac1 (eth1addr) in original firmware
+ 802.3at POE+
+ used as WAN interface
* 12V 2A DC
Flashing instructions:
The tool ap51-flash (https://github.com/ap51-flash/ap51-flash) should be
used to transfer the factory image to the u-boot when the device boots up.
Signed-off-by: Marek Lindner <marek.lindner@kaiwoo.ai>
[sven@narfation.org: prepare commit message, rebase, use all LEDs, switch
to dualboot_datachk upgrade script, use eth1 as designated WAN interface]
Signed-off-by: Sven Eckelmann <sven@narfation.org>
|
||
|---|---|---|
| .. | ||
| qcom-ipq4018-a42.dts | ||
| qcom-ipq4018-ap120c-ac.dts | ||
| qcom-ipq4018-cs-w3-wd1200g-eup.dts | ||
| qcom-ipq4018-dap-2610.dts | ||
| qcom-ipq4018-ea6350v3.dts | ||
| qcom-ipq4018-eap1300.dts | ||
| qcom-ipq4018-ecw5211.dts | ||
| qcom-ipq4018-emd1.dts | ||
| qcom-ipq4018-emr3500.dts | ||
| qcom-ipq4018-ens620ext.dts | ||
| qcom-ipq4018-ex61x0v2.dtsi | ||
| qcom-ipq4018-ex6100v2.dts | ||
| qcom-ipq4018-ex6150v2.dts | ||
| qcom-ipq4018-fritzbox-4040.dts | ||
| qcom-ipq4018-jalapeno.dts | ||
| qcom-ipq4018-jalapeno.dtsi | ||
| qcom-ipq4018-meshpoint-one.dts | ||
| qcom-ipq4018-nbg6617.dts | ||
| qcom-ipq4018-pa1200.dts | ||
| qcom-ipq4018-rt-ac58u.dts | ||
| qcom-ipq4018-wre6606.dts | ||
| qcom-ipq4018-wrtq-329acn.dts | ||
| qcom-ipq4019-a62.dts | ||
| qcom-ipq4019-cm520-79f.dts | ||
| qcom-ipq4019-e2600ac-c1.dts | ||
| qcom-ipq4019-e2600ac-c2.dts | ||
| qcom-ipq4019-e2600ac.dtsi | ||
| qcom-ipq4019-ea8300.dts | ||
| qcom-ipq4019-eap2200.dts | ||
| qcom-ipq4019-fritzbox-7530.dts | ||
| qcom-ipq4019-fritzrepeater-1200.dts | ||
| qcom-ipq4019-fritzrepeater-3000.dts | ||
| qcom-ipq4019-habanero-dvk.dts | ||
| qcom-ipq4019-map-ac2200.dts | ||
| qcom-ipq4019-mr8300.dts | ||
| qcom-ipq4019-oap100.dts | ||
| qcom-ipq4019-pa2200.dts | ||
| qcom-ipq4019-rtl30vw.dts | ||
| qcom-ipq4019-u4019-32m.dts | ||
| qcom-ipq4019-u4019.dtsi | ||
| qcom-ipq4019-wpj419.dts | ||
| qcom-ipq4019-wtr-m2133hp.dts | ||
| qcom-ipq4019-xx8300.dtsi | ||
| qcom-ipq4028-wpj428.dts | ||
| qcom-ipq4029-ap-303.dts | ||
| qcom-ipq4029-ap-303h.dts | ||
| qcom-ipq4029-ap-365.dts | ||
| qcom-ipq4029-aruba-glenmorangie.dtsi | ||
| qcom-ipq4029-gl-b1300.dts | ||
| qcom-ipq4029-gl-s1300.dts | ||
| qcom-ipq4029-mr33.dts | ||